Cable Management

Tripp Lite's Hook-and-Loop Velcro Cable Tie 10 Pack is the must have accessory for keeping bundles of cables manageable. Will not crimp Cat5/Cat6 patch cables like nylon ties when over-tightened, and, unlike nylon ties, are re-usable over and over again. 10" Long by 5/8" Wide x 10 pieces.

More from the Manufacturer

Tripp Lite's 100 Pack of Nylon Cable Ties is the must have accessory for keeping bundles of cables manageable. At 7.5" Long, just zip up the cable tie and clip off the remainder for a clean, organized installation. Provides a minimum tensile strength of 40 lbs. (18 kg.).

More from the Manufacturer

HDMI Port Lock Helps Prevent Accidental Disconnection and Expensive Downtime

Having a cable come loose accidentally can mean the loss of an audio/video signal and costly downtime. The P568-000-LOCK helps you avoid interruptions in your digital signage system by maintaining a secure link without failure. A locking HDMI connection is also invaluable when moving equipment in a rack or removing equipment from tight areas, ensuring the cable always stays connected.

Easy to Install in Just a Few Minutes

This HDMI lock works with any HDMI cable and any device with a fixing or locking screw space above or below the HDMI port. If the device has no screw in the fixing space, one is included. Just secure the included nylon cable tie to the fixing space with the screw, and insert your HDMI cable into the cable tie clamp, pushing the clamp as close to the connector as possible. Then, plug the cable into the device's HDMI port, and insert the cable tie into the clamp, removing all slack, so the HDMI plug cannot come loose. Removing the cable tie from the clamp allows you to unplug the cable.

Lifetime Warranty

The P568-000-LOCK is backed by a lifetime warranty, ensuring reliability and performance.

More from the Manufacturer

Tripp Lite's SmartRack SRCABLEDUCT1U helps eliminate cable stress for your rack enclosure cabinet. The 1U 19-inch horizontal cable manager (finger duct with cover) organizes cables within the SmartRack enclosure or open rack. Required mounting hardware is included.

More from the Manufacturer

Horizontal fiber cable manager routes and organizes network cabling through your 19 in. rack while maintaining proper bend radius.

Features | 1U Horizontal Cable Manager Keeps Your Rack Looking Neat and Organized

Easy to mount on either the front or rear of your rack cabinet or open frame rack, the SmartRack® SRCABLEDUCT1UFC neatly organizes fiber optic, copper and coax cable bundles. This 1U horizontal manager offers proper bend radius to eliminate stress on the cables connecting your network devices. Fingers on either side and pass-through holes in the rear allow convenient access to cabling for routing and separation of bundles. The snap-on cover lets you rapidly add or remove cables and provides excellent protection for them. The cable manager is made from high-visibility yellow steel to help you identify its contents in a crowded rack. All hardware is included for installation on an EIA-standard 19-inch rack.