Audio & Video Consoles/Extenders
-
NVT Phybridge NV-652R Video Receiver - 5280 ft Range - Twisted Pair - Rack-mountable
Features:
- Full-motion CCTV video at distances up to 3,000ft (1km) when used with any passive NVT transceiver; 1 mile (1,6km) when used with NV-653T transmitter
- Exceptional interference rejection
- Built-in transient protection and ground lifting
- Built-in brightness and sharpness controls; blue power LED, green active LED
- Compatible with qualified UTP cameras
- Up to ten NV-652Rs may be rack mounted using the NV-RM8/10 rack panel kit
- Best choice for DVR and high resolution applications over 750ft (225m)
- Limited lifetime warranty
The unparalleled interference rejection and low emissions of the Model NV-652R allow long run video signals to co-exist in the same wire bundle as telephone, datacom, or low-voltage power circuits. This allows the use of shared or existing cable plant. Ground-lifting ensures no annoying "hum-bars" when ground potential differences exist. With built-in transient protection, damaging voltage spike problems are eliminated. The built-in sharpness and brightness controls compensate for cable loss. Learn More$239.13 -
NVT Phybridge 8-Channel Video Transceiver Hub - 3280.84 ft Range - 2 x Network (RJ-45) - Twisted Pair - Category 5 - Rack-mountable, Wall Mountable
Features:
- Compact rack mountable 19" 1U high enclosure features 8 channels and only 1.54" (40mm) deep
- Use with any NVT passive transceiver or hub for full motion CCTV at distances up to 750ft (225m)
- Use with any NVT DigitalEQTM Hub or active receiver as a rack-mountable passive transmitter for distances up to 3,000ft (1km)
- Use with any NVT StubEQTM for distances up to 1,500ft (460m)
- RJ45 video connectivity with optional NV-RJ45A RJ45-to-screw terminal adaptors included
- No power required
- Exceptional interference rejection
- Built-in transient protection
- Supports "up-the coax" type control signal up to 750ft (225m)
- Compatible with qualified UTP cameras
- Limited lifetime warranty
"Up-the-coax" type signal may be sent over the same wire pair at distances up to 750ft (225m).
The unparalleled interference rejection ability of the Model NV-813S Hub allows video signals to co-exist in the same wire bundle as telephone, datacom, or low-voltage power circuits. Perfect for larger CCTV installations where port density and camera number growth are prevalent. With built-in transient protection, damaging voltage spike problems are eliminated.
Learn More$405.26 -
NVT Phybridge Power Supply Passive Video Receiver Hub - 750 ft Range - 10 x Network (RJ-45) - Twisted Pair - Category 5e - Rack-mountable, Wall Mountable, Desktop
Features:
- Provides Class 2 SELV camera power while receiving video transmission and delivering P/T/Z telemetry all over a single 4-pair Cat5e cable
- Standard telecom/datacom structured cabling pinouts per EIA/TIA 568B
- Independently selectable 24VAC-OFF-28VAC with 1 Amp per channel
- Automatic-reset fault protection; transient protection
- Individually floating outputs ensure total ground-loop immunity
- Frequency response DC to 10MHz
- Diagnostic LEDs show load/no load, miswires, and overload conditions
- Use with the NV-216A-PV, NV-218A-PVD, or NV-226J-PV transceiver at the camera
- Power cameras via UTP over significant distances (see Power Distance Chart)
- 1U high; 8" deep; wall, desk, or rack-mountable, 2ft (60cm) BNC Cables included
- Limited lifetime warranty
$1,031.73
