Connectors

The Original EZ-RJ45® fully shielded plug, with an internal ground, combines the performance advantage exclusive to the EZ-RJ45® design with the performance advantage inherent to shielded products to provide an unparalleled solution for the market.

WARNING: Platinum's EZ-RJ45 connectors and crimp tools are designed to work as a system. Platinum Tools' products are NOT intended to be compatible with other brands and such unintended use can result in bad connections, breakage, and human safety hazards, and will also void the warranty. Platinum is not responsible for any unintended uses of its products.

• EZ-RJ45® design allows the wires to pass through the connector so the twists in each pair can be pulled closer to the contacts than conventional plugs.
• Maintaining the twists to the point of termination significantly decreases crosstalk and markedly increases performance.
• Fully shielded products provide reduced pair-to-pair crosstalk, alien crosstalk, and considerably improved immunity to noise at all frequencies.
• Significantly improve Shannon capacity.
• Substantially improve noise immunity at all frequencies, especially above 30 MHz when cable balance starts to significantly degrade.
• Category 6 performance per EIA/TIA B.2. FCC compliant, UL rated. RoHS compliant
• Max Cable OD: 6.60mm (0.260"), Max Insulated wire OD: 1.016mm (0.040")
• For solid round or stranded wire cables.
• Made in the USA
• TAA Compliant

The Original EZ-RJ45® shielded CAT5/6 connector simplifies twisted pair terminations by allowing the wires to be inserted through the connector and out the front for EZ verification of wiring sequence. Applications with RF problems or grounding requirements usually specify to use shielded cable & shielded connectors.

• For use with CAT5e/6+ shielded cable
• For solid round or stranded wire cables.
• Max Cable OD: 7.11mm (0.280"),
• Max Insulated wire OD: 1.016mm (0.040")
• UL Rated, FCC compliant
• TAA Compliant

The EZ-RJ12/11 Connector simplifies twisted pair terminations by allowing the wires to be inserted through the connector and out the front. This allows the technician to easily verify the proper wiring order prior to termination. Use the EZ-RJPRO HD™ Crimp Tool (P/N 100054) or EXO Crimp Frame® with EZ-12/11 Die (100061 & 100073C) for single cycle crimping and trimming of the excess wire. FCC compliant and UL rated. Made in the USA.

• For use in telephone & security installations.
• Faster, easier terminations with reduced scrap.
• For specialized telephone installations & communications equipment.
• For applications requiring custom/specific wire configurations.
• Works on solid or stranded wire.
• Designed for 6, 4, and 2 conductor applications.

Built with a hi-lo stagger design to isolate each conductor at the point of termination making the end result a performance beyond enhanced Cat5e. The internal channels make it a quick & easy prep for termination without using any extra pieces!

Built with a hi-lo stagger design to isolate each conductor at the point of termination making the end result a performance beyond enhanced Cat5e. The internal channels make it a quick & easy prep for termination without using any extra pieces!

• Enhanced Performance
• For round solid wire
• 3 prong contact design
• UL rated, RoHS
• FCC compliant
• Gold plated contacts, 50u
• Round-Stranded available - See part numbers