Accessories

The SRX910LA VT CVR is a heavy duty soft cover designed to work with the SRX910LA vertical transporter. The cover is sized to cover four enclosures and includes two industrial-rated zippers for easy and reliable deployment. The cover includes input panel flaps, allowing the SRX enclosures to be tested without removing the cover. The front section panels are internally reinforced for maximum protection of the speaker grilles. When not used, the SRX910LA VT CVR folds into a compact footprint for storage.

The SRX910LA Base Plate is a universal adapter frame that enables SRX910LA arrays to be ground stacked on top of compatible subwoofers or support structures such as stages, scaffolding, or carts. Using the included M20 screw, the SRX910LA BP connects to any supported subwoofer equipped with a standard M20 pole mount adapter, such as the SRX928S. The rear angle selection bar allows for angles ranging from -15 to +5 degrees. The three included M10 through-holes can be used to permanently attach an SRX910LA array to other support structures. Configurations and load conditions for using the SRX910LA BP can be obtained using JBL Line Array Calculator 3 software. For more information about the base plate and use cases refer to the SRX900 Series Rigging Manual.

The SRX900 RC1 is a universal rain cover used for protecting SRX900 amplifier modules from moisture. The rain cover attaches to the amplifier module using the five included M3.5 fasteners and covers the LCD, XLR and etherrCON® connectors. A Velcro feature allows easy access to the LCD and connectors, while cover's flexible material allows it to drape around the connected cables. Once attached, the RC1 is designed to remain on the product; it does not need to be removed for indoor applications. The RC1 should always be used when SRX900 products are used outdoors. Note that the Neutrik powerCON® TRUE1® TOP power connectors are IP65 rated, and do not need to be covered for outdoors use. For more information on how to attach the RC1, refer to the SRX900 Series Rigging and User Manuals.

The SRX906LA PB accessory is a lightweight pull-back bracket that can be used to implement pull-back of SRX906LA or SRX910LA arrays. The SRX906LA PB attaches to the bottom cabinet of an array and connects to a rear center suspension point to allow for more downtilt than would otherwise be possible using an SRX900 Series array frame alone. JBL's Line Array Calculator 3 software application is used to calculate the required downtilt angle. The SRX906LA PB can support the weight of up to 16 SRX906LA or 16 SRX910LA enclosures (depending on array geometry) and a 1/2-inch shackle (included) can be attached directly to the bracket. For more information about the suspension bar and use cases, refer to the SRX900 Series Rigging Manual.