Accessories

4-slot battery charger replacement cup to enable charging of HC2X/HC5X batteries

• Used to replace a legacy TC21 / TC26 or TC5x HC series 4-slot Battery Charger on single-slot or multi-slot ShareCradle base when migrating from TC21 / TC26 or TC5x HC to HC2X/HC5X.
• No more than one cup shall be installed on a multi-slot ShareCradle base when converting with this 4-slot Battery Charger cup.
• Should replace the TC21 / TC26 HC toaster cup in the same location on the ShareCradle base, usually the left-most slot when facing the cradle.

Power Extension Cable, DC, 6 foot, waterproof

• Connects to vehicle power supply/battery or PS1320 PreRegulator
• 6 ft. long, waterproof
• Internal P/N CB000309A01,NA
• Built to ensure the highest quality, reliability, and performance.
• Works with Zebra's high-end performance products.

Power Extension Cable DC, 6inch, waterproof - Screen Blanking

• Connects to vehicle power supply/battery
• 6 ft. long, waterproof
• Connects to motion sensor switch on forklift to turn off display on device while forklift is moving OR connects to ignition switch on forklift to power down device when ignition is switched off.
• To use both screen blanking and ignition sense functions, an additional wire (not supplied) must be run from ignition relay on forklift and IGN pin on 1616303-001 cable.
• Works with Zebra's high-end performance products.