Accessories

This unit supports A4, A5 (long edge first), Folio, Letter, Legal and Oficio sizes. Only Paper (16 to 36 lb , 60 to 135 gsm) may be used from this unit. Install below any other trays. Paper size, paper and tray-present and tray-low and tray-empty sensing are supported. If the product configuration contains the 2,100-Sheet Tray, the optional caster base is required. The Spacer cannot be used with the 2100-Sheet Tray.

This unit supports up to 500 sheets of paper (20 lb., 75 gsm). Envelopes are also supported with this unit. The Offset Stacker supports bin 'full' sensing.

Genuine Lexmark parts and components are engineered for superior quality and tested to rigorous standards.

Configure your Lexmark

Bins 1 and 2 support various plain, recycled or bond papers and glossy paper (16 to 68 lb., 60 to 256 gsm) in A3, A4, Executive, JIS-B4, JIS-B5, Letter, Legal and Ledger (Tabloid) sizes. The upper bin 1 supports up to 200 sheets of paper with hole punching. Bin 1 has a full sensor. The lower bin 2 supports up to 3200 sheets of paper with stapling, hole punching and offset stacking. Each stapled set may contain up to 50 sheets for 4-position stapling (5,000 staples capacity). Supports Bin 2 has a full sensor. The standard output bin capacity is reduced to 100 sheets when using a floor standing finisher. The lower bin capacity is reduced when stapling is utilised. Hole punching and offset stacking are supported to Bin 2 only. The 2500-Sheet Tandem Tray or 2x 500-Sheet Tray is required to raise the printer or MFP to the correct height for use with the Finisher.